Futaba 6vad

Jumpering the charging circuit diode in
Futaba 6VA "Skysport" transmitters

This modification, when properly done, will not affect the operation of your
transmitter, nor will it void your warranty. However, do not attempt this procedure

unless you are comfortable with soldering electronic equipment!

1. Unplug and remove the battery.
2. Remove screws and open the back cover of the transmitter.

3. Solder a small jumper wire across the diode, as indicated.

4. Reassemble the transmitter, being careful not to pinch any wires. Replace and plug in the battery.